Compatibility Fit for all motorcycles with 3 1/4 Inch flat style led bulbs. Compatible with Harly Electra Glide (FLHS 1987-1993, FLHT 1986-2009, FLHTC 1986-2013, FLHTK 2010-2013); Fatboy FLSTF 1990-1994; Heritage Softail FLSTC 1988-2015; Road Glide (FLTR 1998-2002, FLTRI 1998-2003, FLHR 1994-2013, FLHRCI 1998-2006); Softail Springer FXSTS 1991 1992; Tour Glide FLTCU 1989-1996
3 1/4 Inch 1157 Front LED Turn Signals Built in 48Pcs diode bulbs, each light is brighter 150% than halgon bulbs. Switchback mode, the Outer halo ring for running light, center amber light for turn signals, the ourter halo ring will automatically turn off when turn signal light up.
Smoked LED Turn Singal Lens High quality ABS plastic material, waterproof, no faded after long time explosure; antiscratch and shockproof, protect led bulbs from minor impact effectively, maintain your visibility without weakning halogen / LED light
Easy Installation Plug and Play. You just take off your original lens cover, then pop back the new replacement. Only 5 minutes are required to install.Please flip LED 180 degree to change the direction to lock in when you feel hard to push in,if the LED can not flash, it is need resistors for the turn signal to correct the flash rate back to normal
Package and Warrany 2Pcs Smoked lens cover+2Pcs 1157 Front LED Turn Signals. You are backed by 6-Month since purchase date. Please feel free to contact us if you have any questions
LED strip kits appear to be identical, but actually they can be very different inside.
Some technical details are critical for their performance and reliability.It s better to pick a good design, which has taken them into consideration.After all, you will need to spend time or money on installation.
For each component and each material, takes quality as a priority over cost.
The contents below explain some of the key points.They will help you understand what they are and why they matter.
DUAL-LAYER PCBS & EXTRUDED SILICONE TUBES
More Durable, Flexible and Less Likely For LEDs to Fail
chooses dual-layer PCBs for the LEDs and cover them with transparent silicone extrusions.
The dual-layer PCBs are more resistant to pulling, bending or twisting, which are common causes for the LEDs to go off on single-layer PCBs.The silicone extrusion is an upgraded industrial technique, not bringing negative chemical reaction on LEDs, which shortens their life span.Last but not least, silicone extrusions are more flexible for curved surfaces, even without a hot wind gun to preheat.
Read more
INDUCTOR & CAPACITOR
