1. Start by measuring your seat and make sure the air cushion you are purchasing is the correct size. 2. Remove the seat from the motorcycle and place it on a flat surface. 3. Take the air cushion and place it on the seat. 4. Secure the air cushion to the seat by using screws …
Tell you how to install a motorcycle seat air cushion Read More »
1. Begin by loosening the mounting bolts with a screwdriver or wrench. Loosen the bolts enough to allow you to slide the beak nose cone onto the mounting brackets. 2. Once the beak nose cone is in place, tighten the mounting bolts securely. 3. Next, mount the beak nose cone to the motorcycle frame using …
Tell you how to mount a motorcycle beak nose cone Read More »
1. Begin by disconnecting the negative battery cable from the ATV. 2. Remove the necessary body parts to gain access to the starter motor. This may include plastic covers and/or the seat. 3. Disconnect the wiring harness from the starter motor. 4. Unbolt the starter motor from the engine block. 5. Install the new starter …
1. Put on safety gear, including gloves and safety glasses. 2. Locate the drive belt on the motorcycle. It is usually behind the alternator and drive pulleys. 3. Disconnect the battery and remove any components that need to be removed to access the drive belt. 4. Remove the old belt and inspect it for signs …
1. Start by removing the wheels from your ATV. Use a socket wrench to loosen the lug nuts, then remove the wheels. 2. Loosen the axle nut, which is located on the axle shaft. Use a socket wrench to loosen the nut. 3. Place a jack underneath the ATV frame, near the axle. This will …
1. Remove the old pedals: Start by locating the two mounting screws that hold the pedals in place. Remove them with a Phillips head screwdriver. Once the screws are removed, the pedals should easily slide out. 2. Install the new pedals: Place the new pedals in the same place as the old pedals. Line up …
1. Remove the wheel nut and axle: Use a wrench to remove the wheel nut and axle. Start by loosening the wheel nut and then use the wrench to pull the axle out of the wheel. 2. Remove the wheel hub: Use a flat-head screwdriver to pry the wheel hub off the wheel. If the …
1. Park the lawnmower on a flat surface and make sure it’s turned off and the engine is cool. 2. Remove the spark plug wire from the spark plug. This will ensure the engine won’t start while you’re replacing the wheels. 3. Remove the wheel nuts that hold the wheel in place. Depending on the …
1. Begin by disconnecting the spark plug and removing the spark plug wire from the ignition coil. 2. Remove the screws that hold the coil in place and carefully remove the coil from its mounting bracket. 3. Clean the exterior of the coil with a clean cloth or shop towel and inspect the coil for …
Tell you how to repair the lawn mower ignition coil Read More »
1. Loosen the axle pinch bolts: The axle pinch bolts are the bolts that secure the axle to the frame of the motorcycle. You will need to use an appropriate sized Allen key or socket wrench to loosen the bolts. 2. Remove the axle: Once the axle pinch bolts are loosened, you can remove the …