1. Remove the lug nuts from all four of the ATV’s current rims. Use a lug wrench to loosen the nuts. 2. Lift the ATV up off the ground and place it on jack stands. This will give you room to work on the ATV and make it easier to access the rims. 3. Remove …
1. Gather your tools. You will need a lug wrench, a tire iron, a tire jack, a flathead screwdriver, a rim guard, and a tire pressure gauge. 2. Secure your ATV. Place your ATV on a flat, level surface. Make sure it is firmly supported. 3. Remove the wheel. Use the lug wrench to loosen …
1. Lift the ATV off the ground using a jack or hoist, making sure to use a secure, level surface. 2. Remove the wheel nut using a socket wrench. 3. Remove the axle nut from the axle, if applicable. 4. Unscrew the brake caliper and rotor from the wheel, if applicable. 5. Remove the wheel …
1. Remove the battery cables from the golf cart. Make sure to check the battery voltage before removing the cables. 2. Disconnect the wires from the ignition coil. Typically, this is done by removing the mounting screws and then sliding the wires off the coil. 3. Unscrew the mounting bolts that secure the coil to …
Tell you how to replace the golf cart ignition coil Read More »
1. Start by finding the adjusting barrel on the throttle cable. The adjusting barrel is located on the engine side of the cable, usually at the carburetor end. 2. Remove the adjusting barrel from the cable. This is usually done by unscrewing the barrel from the cable. 3. Once the barrel is removed, you should …
1. Drain the fuel tank and remove it from the vehicle. Disconnect the fuel line and the throttle cable. 2. Remove the air box and air filter if necessary. Unbolt the carburetor from the intake manifold and disconnect the choke cable. 3. Remove the float bowl by loosening the screws and slide the bowl off …
1. Start by measuring your seat and make sure the air cushion you are purchasing is the correct size. 2. Remove the seat from the motorcycle and place it on a flat surface. 3. Take the air cushion and place it on the seat. 4. Secure the air cushion to the seat by using screws …
Tell you how to install a motorcycle seat air cushion Read More »
1. Begin by loosening the mounting bolts with a screwdriver or wrench. Loosen the bolts enough to allow you to slide the beak nose cone onto the mounting brackets. 2. Once the beak nose cone is in place, tighten the mounting bolts securely. 3. Next, mount the beak nose cone to the motorcycle frame using …
Tell you how to mount a motorcycle beak nose cone Read More »
1. Begin by disconnecting the negative battery cable from the ATV. 2. Remove the necessary body parts to gain access to the starter motor. This may include plastic covers and/or the seat. 3. Disconnect the wiring harness from the starter motor. 4. Unbolt the starter motor from the engine block. 5. Install the new starter …
1. Put on safety gear, including gloves and safety glasses. 2. Locate the drive belt on the motorcycle. It is usually behind the alternator and drive pulleys. 3. Disconnect the battery and remove any components that need to be removed to access the drive belt. 4. Remove the old belt and inspect it for signs …
Unleash the thrill of the ride with our top-quality parts and accessories! From ATVs to motorcycles, we provide reliable solutions that enhance performance and adventure. Gear up for your next journey with confidence and style. Explore the great outdoors with premium equipment designed for every enthusiast!
Address: East Industry Center, Wenling, Zhejiang, 317500, P.R.China
Email: info@hqpart.com
Copyright © 2008 HQPART Lawnmower Tractor ATV UTV Go Kart Scooter Golf cart motorcycle mini bike snowmobile drift trike bicycle parts customized OEM Manufacturer.