centrifugal clutch 10t 41 20mm bore clutch for go kart

Go Kart Clutch 3/4 Bore 10T For 40 41 420 428 Chain Minibike Baja MB165 MB200
Outside diameter: 10 Tooth 19mm (3/4″) or 20mm bore ,Fit #40/41/420 chain
Total width: 3″
Clutch back to sprocket: 2 1/2″
Fits:
2-6.5hp Honda & Honda Cloned Engines GC160, GC190, GX120, GX140, GX160, GX200
Perfect For Go Kart Minibike Baja Mini Bike MB165 & MB200 (Baja Heat, Mini Baja, Baja Warrior)
Common clutch for 3.5-7hp engines using #40/41/420 chain
Briggs & Stratton and 2 – 6.5 HP With 3/4″ Shaft
Tecumseh Engines 2 – 6.5 HP With 3/4″ Shaft
Set Screws NOT Included. Mounts onto crankshaft using bolt and washer on the end of the crankshaft.
( Clutch does not need set screws as long as the end of the crankshaft is threaded to accept a bolt. Most go kart clutches are held onto the shaft with a bolt and larger washer. Extra washers if needed are used on the crankshaft to space clutch. )

428 Clutch : 13 Tooth 19mm (3/4″) or 20mm bore
Fits a 428 chain.
19mm metric bore.
HD 428chain clutch for Honda import Gokart and Buggy engines with parallel 19mm engine drive shafts.

Fits the wide range of Honda import clone engines used in Gokarts and Buggies normally on 3.5-7HP 170F engine styles.

Package Contents depends on your choice from the dropdown box